Low Rider 10.5 Turn 540-2 Pole motor:
Certified stators which means every motor will have a stator that is wound to a very tight tolerance of 0.50 mOhm between motors when measured from the A , B or C solder tab to the collector ring.
34mm Diameter with offset mounting holes which allows the motor to be mounted 1mm lower than current motors for the lowest possible center of gravity.
50mm Length keeps the weight closer to the center of the chassis for optimal weight balance.
This motor only weighs 141 grams which makes one of the lightest stock motor on the market.
7.2 x 12.5 sintered 42UH rotor.
Warning: Due to the high magnetic flux inherent to the stator design, unloaded sensor deviation tests may appear to vary between bench tests. This is normal and is not a factor on a loaded motor on track.
Caution about timing: this motor has a LOT of KV. Testing has shown best results with timing approximately 8 degrees less than conventional “thin leg” Spec motors. Check your temps until you figure out timing and gearing!
We recommend you start with one teeth lower then your previous motor and adjust if need be.
LowRider 10.5T 540-2 Pole
- Product Code: LR10.5T
- Availability: In Stock